- Now properly signalling a manual stop to the script so post test actions will be followed correctly, previously all stops during a script were treated as "Automatic"
- Fixed a bug when USB3 plug fails benchmark mode in USB high-speed mode, this could cause an error if using the USB3 plugs on a USB2 port when the test switched from benchmark to loopback
- Reduced the amount of time the 2D test will wait between tests when on a low duty cycles
- Fixed a window redraw issue where the 2D lines and bitmaps test was not always updating correctly after the lines test on some systems
- Fixed some display issues (wrong hard drive letter shown) sometimes when a test config was created from default or moved between system with different disk setups
|
|
